This custom valve spring kit goes far beyond typical “performance” BMW spring kits. Rather than double springs or springs that are much too stiff, resulting in increased resistance and wear, our springs are an engineered solution.
Designed for use with the Sunbelt SportCams, this kit was engineered with extensive Spintron testing. This ensures the springs apply the correct amount of pressure to keep the valves in contact with the cam lobes without any unnecessary brute force (seat pressure) that may cause parasitic losses, wear, and fatigue. This kit will allow the valvetrain to rev to 9,500 RPM’s with Sunbelt cams, but most engines will be bottom-end rev limited well below this level. For most engines with stock based rotating assemblies we suggest a non-sustained maximum limit of 7,400 for 3L and 7,200 for 3.2L engines.
Kit includes valve springs, locaters, and retainers. Fits all 1992-2000 M50 engine based cars, including 323, 325, 328, M3, and Z3.
Related products
Disclaimer
California Emissions Regulations:
Please be aware that certain products offered on our website may not be street-legal in California and may not comply with the state’s stringent emissions standards as regulated by the California Air Resources Board (CARB). Products not CARB-approved are intended for off-road or competition use only.
By purchasing any products from this site, you acknowledge and agree to comply with all applicable federal, state, and local laws, and you assume all responsibility for the installation and use of the products in accordance with these regulations. Epic Motorsports is not liable for any violations of these laws.
For more information about California’s emissions regulations, please visit the CARB website.